ATR plug and play GY6 engine harness will eliminate the need to fuzz around with wiring your engine swaps! Reduce the chances of errors and problems. Pre-labeled and ready to go!
For those who are looking for a 8-Pole harness, please be sure to add the 8 Hole harness jumper by clicking button so that it will allow you to run a 8 pole charging system! Jumper plugs into rectifier spot on ATR Harness. We also Recommend a 4-pin Rectifierwhich will plug into Jumper directly.
See pics on how 8 pole jumper plugs into harness.
If using the 5 pin rectifier that comes with the harness with an 8-pole stator. You must cut off plug on 5 pin rectifier and hard wire.
Red from Jumper to red on Rectifier
Green From jumper to Green on Rectifier
Pink from Jumper to Yellow on rectifier(use position where they would have gone if you did not use jumper)
Yellow from Jumper to Yellow on rectifier(use position where they would have gone if you did not use jumper)
You will have an extra yellow that can be cut once tested.
Some times the pins come undone here's where they go:
MAKE SURE ALL GROUNDS ARE GOOD. IF YOU HAVE POWDER COATED BOTH FRAMES. PLEASE REMOVE COAT OR PAINT WHERE THE TWO FRAMES MEET FOR PROPER GROUND. ALSO DON'T FORGET TO GROUND THE STOCK OEM GREEN HEADLIGHT HARNESS. MOST ISSUES NO START ISSUES ARE FROM POOR OR NO GROUND.
Syndicate Auto Salon is not responsible for any electrical issues that may result in the installation of a GY6 Wire Harness and should be installed by a professional.